MODEL H2872/H2873
SHELF RACK
INSTRUCTIONS
6.. After.shelving.unit.is.assembled.and.aligned,.
tighten.all.the.nuts.and.bolts.
Model H2872 Inventory
A. Shelves........................................................ 3
B.. Legs............................................................. 4
C.. Corner.Braces........................................... 16
D.. Bolt.Bag....................................................... 1
—Plastic.Feet.............................................. 4
—Slotted.Screw.M6-1.x.10....................... 56
—Square.Nuts.M6-1................................. 56
If you need additional help, call our service depart-
ment at: (570) 546-9663.
Model H2873 Inventory
A. Shelves........................................................ 5
B.. Legs.(shipped.in.separate.box)................... 4
C.. Corner.Braces........................................... 16
D.. Bolt.Bags..................................................... 2
—Plastic.Feet.............................................. 4
—Slotted.Screw.M6-1.x.10....................... 72
—Square.Nuts.M6-1................................. 72
Assembly
Figure 1. Models.H2872.&.H2873.
1.. Lay.the.legs.on.the.floor.so.the.corners.face.
out. and. press. a. plastic. foot. on. one. end. of.
each.leg..Use.the.diagram.on.the.next.page.
for.assistance.during.assembly.
A
2.. Secure.the.bottom.holes.of.the.corner.braces.
to. the. inside. corners. of. the. legs. with. M6-1.
x. 10. slotted. screws. and. M6. square. nuts..
Note–Finger tighten bolts until assembly is
complete.
B
C
3.. Place.a.shelf.on.the.inside.corner.of.the.leg.
and.corner.brace,.then.insert.an.M6-1.x.10.
slotted. screw. through. the. leg,. corner. brace.
and.shelf..Secure.with.an.M6-1.square.nut..
Insert. the. second. screw. through. the. corner.
brace.and.shelf.
D
Figure 2. Inventory.parts.
4... Continue. around. each. corner. of. the. shelf.
until.complete.
Exceeding the maximum weight limit or
tipping the shelf can cause severe injury
or death. DO NOT exceed the weight limit
(H2782: 600lbs; H2783: 1000lbs) and secure
the unit to wall or other stationary object.
5.. Determine.the.location.of.remaining.shelves.
and. repeat. steps 2–6.. Note–Corner brac-
es are only used on the top and bottom
shelves.
|